Operation in AT Mode
20
MicroLink ISDN/PCC-16
Manual © 1997 ELSA GmbH
4.2.2 Instructions for Your First ISDN Connection under DOS
To establish a test connection, for example to our Support BBS
ELSA ONLINE
, please proceed as
follows:
n
Start the CAPI driver DSS1CAPX.EXE (for Euro-ISDN), US__CAPX.EXE (for US protocols) or
ISDNCAPX.EXE (for 1TR6).
n
Start the FOSSIL driver cFos by calling STARTCFOS.BAT or by entering
cfos i
.
n
Start
Telix
and enable the INT14 mode. The COM port must be set to
COM 2
. This port is the
default link to the FOSSIL driver via the interrupt 14h (if you have started cFos with a different
port setting, you must set this port in
Telix
as well). In INT14 mode the COM ports are not
related to physical serial interfaces, therefore you need not set any bit rate or data format. In
ISDN operation,
Telix
always uses the highest possible bit rate.
n
To establish the connection, type
ATD 0241 9177 7800
(from within Germany, otherwise enter
your international access code (+49) and omit the first
0
) in terminal mode and press <CR>.
Telix
will establish an ISDN connection with the Support BBS
ELSA ONLINE
. You can terminate the
connection at any time with the
Telix
command <Alt><H>.
