Elos BIOTOPUS II, Руководство оператора

Страница: 11 / 72

BIOTOPUS II - Operator manual
Page 11
Quick Start Setup
Here is the absolute minimum information you need to get started with your new
BIOTOPUS II. After you satisfy your urge to hook it up and turn it on, please read the
entire manual; you will learn how to maximize the effectiveness of this fi ne product:
CONNECTIONS: CONNECTIONS:
The following description may depend on your set-up:
1. Position the Display in the most convenient place. The controller comes with a
mounting hanger for easy installation. Use the hanger to attach the controller to the
wall. Your Biotopus II can be located in any dry location. The controller is not water-
proof and cannot be sub-merged, permitted to get wet or exposed to high humidi-
ty.
AVOID SPLASHING THE UNIT.
2. Connect the probe(s) to the DISPLAY UNIT and position them into the aquarium
or into the fi lter so that the top of the probe(s) is above the waterline. All the probes
should be positioned so that ONLY ABOUT 2/3 of the probe shaft is immersed in wa-
ter. Select a probe installation that will allow the pH and ORP probes to be located
within 15 cm (6 inches) of the temperature probe.
3. Connect the DC power supply to the DISPLAY UNIT
(ONLY NECESSARY FOR CONTROL VERSIONS):
4. Position the MULTIPLUG in the most convenient place. The Multiplug comes with a
mounting hanger for easy installation. Use the hanger to attach the Multiplug to the
wall, in any dry location. The Multiplug is not waterproof and cannot be sub-mer-
ged, permitted to get wet or exposed to high humidity.