Elnec BeeHive204, Руководство пользователя, Страница: 147 / 179

PG4UW MC
147
support to customize Start-End device addresses. Some devices (for example NAND
FLASH) have customizable sector or page count/range, and the "whole device" means
range of device specified by these options.
Device / Program
This command executes device programming. The control program reports a result of this
action by messages in INFO window and LOG.
The menu command Device / Device options / Operation options of PG4UW allows to
customize areas to be programmed, and set other operation options during creating a project.
Device / Erase
This command executes device erase. The control program reports a result of this action by
messages in INFO window and LOG.
The menu command Device / Device options / Operation options of PG4UW allows to
customize available operation options during creating a project.
After Erase, if device (chip) doesn't support erase verify command, the blank check operation
takes place to verify successfulness of Erase operation.
Programmer / Search for Programmers
This command is used for searching and managing multiprogramming systems connected to
one PC. It is possible connect a few same type single site programmer or multiprogramming
system up to 64 programming sites to one PC.
Select multiprogramming system connected to your PC.
Press button search.
Using arrows button organize founded connecting programmer to programming sites.
Press Accept button