Elnec BeeHive204, Руководство пользователя

Страница: 136 / 179

Elnec s. r. o.
136
Select of sub-projects and build final Multi-project file
Load of existing Multi-project file *1
Start device operation of recent Multi-project
*1 Note: Existing Multi-project file can be loaded from main menu of PG4UW using menu File /
Load project or from Multi-project Wizard by Load multi-prj command.
Multi-project Wizard contains following controls:
Button Load multi-prj is used for load of existing Multi-project file.
Button Build Multi-project is used for build of new Multi-project file, which uses projects
listed in table Sub-projects .
Table 1: Sub-projects contains list of projects that are included in recent Multi-project.
Button Add project is used for adding of new project file(s) to list of project files in Table1.
Button Remove project is used for removing of selected project file from list of project files
in Table 1.
Buttons Move up a Move down are used for moving of selected project in Table 1 one
position up or down. Projects are processed in specified sequence order, the upper-most
(#1) as first.
Button Help show this help.
Buttons of device operation Blank, Verify, Program, Erase, or Run are used for running of
selected device operation on all chips (sub-devices) listed in table Sub-projects.
In "Multi operation" mode , one of all available operations can be run at a time (the same
operation on each sub-device).
In "One operation" mode , only one operation can be run (the same operation on each
sub-device) or each subproject can run it's own (one) operation, depending on projects the
Multi-project consists of.
Following two basic actions have to be performed when using Multi-project to program
Multi-chip devices (similar also for Single-chip devices):
Making (building) of Multi-project (or Multi-project file)
Using of Multi-project for running of device operation
Making (building) of Multi-project (or Multi-project file)
Following steps are recommended when making Multi-project file:
Create "classic" projects, one project for each sub-device of multichip device.
Projects are created in the same way as projects for generic devices:
select sub-device according to required chip of multichip device *1
set device parameters, settings, and load required device data to buffer by
Load file
command in PG4UW
optionally make test of device operation by running the device operation on device
if everything is OK, the project file can be created by
Save project command
Select Master multichip device, the Multi-project has to be used for. After selection of
multichip device, Multi-project Wizard is automatically opened.
In Multi-project W izard add required projects by Add project button . Each project
represents one sub-device of multichip device.
After completing of sub-project selection, use button Build Multi-project to create final Multi-
project file. Program will prompt for name of new Multi-project file. Final Multi-project file will
contain all sub-projects listed in Table 1: Sub-projects.