Daily cleaning operation
28
BA_Elmasolvex_SE_EN_Vers. 03.2018
© Elma Schmidbauer GmbH
Press the operating handle (
see Chapter 3.8
) and move the
drive unit to the lowest position of the media tank. In doing so,
the cleaning basket / movement holder should be completely
immersed in the medium.
Now release the operating handle.
Set the required time for the process step (
STEP TIME
) and the
speed (
SPEED
) at the respective rotary knobs (
Fig. 3.10.A/B
).
Note the recommendations in
Chapter 6.6.1
as orientation aid
for these settings.
The cleaning machine now starts for the specified time.
A signal sounds after expiry of the specified time.
Now push the drive unit into the spinning position (cleaning
basket / movement holder over the medium) (
Fig. 3.8.4
) and set
the required parameters (cleaning time and intensity) for this.
A signal sounds after expiry of the specified time.
Now push the drive unit into the change position (cleaning
basket / movement holder over the media tank) (
Fig. 3.8.3
) and
the move the drive unit over the next media tank.
Proceed in the same way for the 3 rinsing steps in the media
tanks #2 - #4.
In addition to the settings for the time and the speed, also press
the button for the heater.
The heater switch indicates from its illumination that the hot air
fan in the drying chamber is activated.
Note in relation to the parts to be cleaned that the rotation
speed in the drying chamber must never be too high. Note the
instructions in the settings recommendations (
Chapter 6.6.1
).
For switching off before expiry of the specified time
preselection: Turn back the
STEP TIME
rotary knob to the
off
position.
6.6
End of the cleaning program
After the last process step (drying chamber), move the drive
unit back to the starting position (over media tank #3).
You can now remove the cleaning basket / movement holder
from the mounting (see
Chapter 6.3
).
Depending on the retention time in the drying chamber, the
cleaning basket / movement holder can still be hot immediately
after the program end.
Let the cleaning basket / movement holder cool down for a few
minutes in the end position or use suitable gloves for holding it.
However, as a cooling down phase is performed in the drying
chamber after the hot air drying, the cleaning basket /
movement holder is already cooled down slightly.
Preselecting time
and speed
Spinning position
Change position
Rinsing
Drying
ATTENTION
Removing cleaning basket /
movement holder
CAUTION
