Initial commissioning
22
BA_Elmasolvex_SE_EN_Vers. 03.2018
© Elma Schmidbauer GmbH
Fire and explosion hazard!
When handling flammable materials, observe the applicable
safety regulations according to the safety data sheet of the
respective solvent.
Keep all kinds of ignition sources away.
Prevent ignition sparks from electrostatic discharge. Discharge
possible electrostatic charges (body charge) before you handle
flammable materials by touching any grounded equipment: e.g.
water tap, metal surface of the case of the cleaning machine or
use ESD protection equipment (ESD armband).
If liquid escapes while replacing the media tank, this must only
be removed using a dry cloth (to prevent electrostatic
charging).
It is best to fill the media tanks in sequence. Start with the
media tank #1 (
Fig. 5.2.#1
):
Fill the media tank with the appropriate media up to the marking
(
Fig. 3.11.C
). Further information for selection of the suitable
cleaning and rinsing solution can be found in Chapter 7.
Pay attention to the correct positioning of the media tanks in the
recesses provided for them in the base of the cleaning
machine.
Close the media tanks when not in use with the covers provided
for them.
The fill level of the medium must be within the marking for
proper operation of the cleaning machine and optimum
cleaning result
(Fig. 3.11.C).
Too low fill level (below the Min. marking) causes
unsatisfactory cleaning results.
Overfilling (above the Max. marking) results in the liquid
sloshing out of the media tank.
Danger of injury from rotating parts!
For proper use of the cleaning machine, all 4 media tanks must
be placed in the positions provided for them in the cleaning
machine.
Only start the cleaning program if all media tanks are correctly
filled and placed at the positions intended for them.
DANGER
Procedure
ATTENTION
CAUTION
