Elma ELMA-1336, Инструкция по эксплуатации

Страница: 12 / 29

10
3. Press SET key to enter the setting target values mode, the annunciator
“
SET
REF
” and the previously set target values are displayed. If no target is
currently set, the display shows o
’s for all parameters.
The first line one or more decimal points blinking.
4. Press

and

key to select the desired decimal point location. If the set
target value does not have a set decimal point, all four of the line
’s decimal
points blink.
5. Using

and

key, position the cursor on the all parameters element to
adjust.
6. Using

and

key to change the selected parameter element value.
7. You can cancel the entry procedure by pressing the SET key.
8. Recheck you entries to be sure that they are correct, and then press

key to
store them, so that they become the target value.
You can view the currently set target by press

key.
If any of the values you have entered are
outside of permissible range of the
corresponding parameter, the display shows
“
ErrA
”, and then returns to the beginning of
the
SET
mode. Reenter the values.
5-3-3 Taking the color difference measurement
1. Aim the receptor at the light source you want to measure. The display shows
the color difference measurement results.
2. Press key to cycle switch displaying the ( Ev, x, y)

( Ev, u
’, v’)

( Ev,
λd, Pe)

( Ev,
λd, Pc)

( X, Y, Z) readings.
3. Press H key, if the displayed value need to be hold. In H mode, press
MODE key and key to cycle switch display the other measured values,
press Time key to display the held date and time and holding down the
