Elliott SpeedCut SCT78, Инструкция по эксплуатации и техническому обслуживанию

Страница: 7 / 42

SpeedCut 7
Installation & Hookup
The SpeedCut was designed and manufactured to conform to high standards of performance.
For this machine to provide satisfactory service, it is necessary
that it be properly installed, operated and maintained.
This manual has been prepared to assist you in carrying out these functions. We urge you to study the
manual and follow these suggestions.
Uncrating
Carefully remove the protective crating so the saw and its parts are not marred or otherwise damaged.
Upon receipt of machine, uncrate and check all parts. In case of loss or damage, file Proof of Loss
Claim with carrier. Remove rust preventive from vertical posts using mineral spirits. Coat with light oil.
The SpeedCut has integrated forklift pockets at the back and can be moved with a forklift.
Utility Hook-Up
The use of a qualified electrician is always recommended when connecting the saw to the main power
supply. Electrical codes differ from area to area and it is the customer’s responsibility to ensure their
saw complies with applicable codes. Your SpeedCut is prewired at the factory for a specified voltage.
Check the motor and electrical panel to ensure that they are wired to correspond to your electrical
power supply. Consult the schematics for further detail.
Mounting
The SpeedCut comes with six (6) mounting holes in base. Six (6) Machine Leveling Bolts are also
included with the SpeedCut. If mounting machine to floor, use six (6) 1/2” x 4” anchoring bolts to
mount unit to concrete floor and metal shims to ensure machine is level in all directions. It is not
required to anchor the machine to the floor.
NOTE: All fasteners and bolts are SAE.