Elliott SpeedCut SCT78, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 42

SpeedCut 11
Installation of Accessories
Bi-Metal Bandsaw Blade
See Replacing Bandsaw Blade on page 20. Also see Breaking In The Blade on page 22.
Minimum Quantity Lubricantion (MQL) System
A MQL Mist Lubrication System is a standard feature on the SpeedCut. A very thin film of lubricant
is spread on the teeth of the blade just before the blade contacts the tube. As the heat from the cut
is absorbed by the lubricant, the liquid is dissipated from the blade and any resulting chips.
Environmental hazards and disposal costs are minimized, the cutting speed is increased,
and the blade life is prolonged.
NOTE:
The MQL Lubrication System will come pre-optimized. Adjusting or changing the rate
of lubricant flow prior to initial operation may lead to dry cutting or waste of lubricant. If the lubrication
does not appear as mixed mist or spray please see the Adjustment and Repair section on page 32.
To install the MQL Mist Lubrication System:
1. Remove plug from inlet at top of MQL.
2. Remove reservoir from shipping location inside bandwheel cover.
Thread reservoir onto MQL inlet.
3. Connect (orange) float level sensor to bottom of reservoir.
4. 90 psi air supply should be provided to machine via 1/4” air hose
near back electrical panel.
NOTE:
Ensure that MQL Lubrication System is “primed” prior to initial cut.
To do this, turn COOLANT switch to ON and then press BLADE START.
Allow to run until liquid can be seen from the MQL nozzles. For added lubrication visibility,
it is recommended to add a few drops of colored food die prior to priming the system.
Bundle Support Table (optional)
Unbolt from shipping location, carefully remove the Bundle Support Table with a forklift or crane and
position in front of the SpeedCut to support the tube bundle to be cut. Included with each Bundle
Support Table is a Ratchet Strap for securing the bundle to the Bundle Support Table.
NOTE:
All fasteners and bolts are SAE.