Elliott SpeedCut SCT78, Инструкция по эксплуатации и техническому обслуживанию

Страница: 31 / 42

SpeedCut 31
Maintenance Instructions
The proper performance and service life of every machine depends on how well it is maintained.
The following should become a regular routine of operations.
Weekly
1. Clean & Lubricate Exposed Surfaces
a.) Wipe exposed surfaces free of dirty oil, chips and dirt.
b.) Apply a thin coat of oil, Symbol 2190TEP, or equivalent to machine’s surfaces.
2. Inspect Hydraulic Oil Level
a.) De-energize circuit. Tag ‘OUT OF SERVICE’.
b.) Locate site gauge on the hydraulic tank.
c.) Inspect oil level. Proper oil level is 1” from top of sight gauge.
d.) Fill as required with Mobil DTE 25 Hydraulic Oil or equivalent.
e.) Remove safety tag. Energize circuit.
NOTE:
To access the fill port on the standard pump, the case for the hydraulic pump
may need to be temporarily removed. Once removed, the fill port can be located in
the lower left hand corner (above reservoir) when facing the back of the machine.
WARNING
!
To reduce the risk of injury, always unplug your
machine before performing any maintenance.
Never disassemble the machine or try to do
any rewiring on the machine’s electrical system.
Contact Elliott for all repairs.
WARNING
!
Cutting head should be at lowest extremity when
inspecting oil level.
WARNING
!
Follow appropriate lock-out / tag-out procedures
prior to performing maintenance on this machine.
Lock-out / tag-out handle can be found at rear of
unit near electrical panel.