Elliott SpeedCut SCT78, Инструкция по эксплуатации и техническому обслуживанию

Страница: 19 / 42

SpeedCut 19
Blade Instructions
When correct feed is being employed, the blade will cut steadily and the micro switch will function
occasionally to open and close the solenoid valve. The yellow FEED ON light on the top of the control box
indicates that the saw is feeding. When the solenoid valve closes, the light goes out.
After a correct feed has been established, the position of the cutting speed control dial should be noticed,
and this location maintained while cutting similar size and type material. Always keep the cutting speed
control within cutting limits, as shown on dial, during actual cutting operations.
Adjusting Spring Pressure
As the spring is compressed on the blade micro-switch assembly, more pressure must be exerted against
the blade before the micro-switch functions. The micro-switch spring controls the pressure against the blade
and considerable discretion should be used before making any change. However, it may be necessary at
times to adjust the spring pressure when radically different materials are to be cut. This adjustment can be
made by turning the knob directly mounted to the blade micro switch on the left blade guide.
Blade Speed Control
Blade Speed is indicated on the speed display on the panel. Speed is indicated in feet per minute. Control
knob is graduated in percentage from zero to 100 percent. Blade speed is adjusted with
the control knob on the front control pedestal of the machine.
Emergency Stops
During the cutting cycle, when frame is in downward travel, all operations can be stopped immediately
by pressing BLADE STOP buttons or EMERGENCY STOP button. When in upward travel, this can be
accomplished by pressing the FRAME STOP button.
Blade Speed Display
Blade Speed Adjustments
(TRAVERSE)
Control Panel
EMERGENCY STOP BUTTON