Eliwell RadioAdapter, Руководство пользователя

Страница: 10 / 12

Radio
Adapter
Pag. 10/12
3.1 - REPLACING THE PAN-C
When a PAN-C is found to be faulty, replace it with a new RadioAdapter.
Follow the steps below when replacing a faulty PAN-C with a new one.
Power
Supply
Power
Supply
Power
Supply
Supervisor
1 2 3
1 - Disconnect and remove the faulty
PAN-C. 2 - Place a new Radio Adapter in the
place of the PAN-C just removed.
Set the switch on the Radio Key to
position 5.
Connect the
Radio
Key to the
Radio Adapter and wait for the
YELLOW LED (P) on the Radio Key
to light up.
3 - Disconnect the Radio Key and
connect the new PAN-C to the
network
3.2 - REPLACING A NODE 3.3 - REPLACING A DEvICE
When a NODE is found to be faulty, the component must be
replaced with a new
Radio Adapter.
Follow the steps below when replacing a faulty NODE with a
new one:
- Disconnect and remove the faulty NODE.
- Place a new
Radio Adapter in the place of the NODE you
removed.
- Install and configure the new NODE following the steps
outlined in section “
How to install a NODE ”.
- Repeat the PAN-C configuration as described in section 2.4
Configuring the PAN-C
Follow the steps below when replacing a faulty device with a new
one:
- if the new device has the same address (Televis or Modbus) as
the old one, just connect it to the NODE.
- if on the other hand the new device has a different address
(Televis or Modbus) from the old one, the respective NODE will
have to be Reset (see section “
Resetting a NODE
”)
3.4 - RESETTING A NODE
Power
Supply
- Disconnect the device from the NODE.
- Set the switch on the Radio Key to position 1.
- Connect the
Radio
Key to the NODE and wait for the GREEN LED (N) on the
Radio
Key to light up.
The NODE has now reset.
- Disconnect the Radio Key and configure the NODE following the steps outlined in sections “ Address
configuration and searching for connected devices “ and “ Saving settings ”.
3 - TROUbLESHOOTING