Elite Greenhouses 8'5" Wide Thyme, Инструкции и иллюстрации

Страница: 37 / 40

8. The built in base/cill can now be attached to the facing bolt slot of the partition corner bar (in
the same way you did in the original door end assembly). N.B. If you have a brick base you
will need to trim off with a hacksaw the first 2” of the overlapping part of the cill to facilitate
a snug fit (dwarf wall model only).
9.
Now attach the built in bases to the 2 side base sections of the greenhouse. Firstly bolt an an-
chor bracket on each end of the partition built in base. If you are on flags or concrete cut off
the surplus metal of the legs. Position the cill under the lip on the built in base sections as you
did on the door end assembly.
10. Insert glazing beading into all the vertical glazing bars.
11. You can now attach the 1st, 2nd, 6th and 7th glazing bars to the built in base/cill, and the 3rd
and 5th glazing bars to the bottom door end cill using the rectangular plate if built in base, or
bottom cill/tab cill if dwarf wall as previously done on door end assembly.
12. Insert 4 bolts into the 1st, 3rd, 5th and 7th glazing bar. Insert 1 bolt into the 2nd and 6th glaz-
ing bar. The top bolt in all cases is to be attached to the holes in the roof corner bar.
13. Insert 3 bolts into the top of the 1st, 2nd, 6th and 7th glazing bar, and 4 bolts into the 3rd and
5th glazing bar—the last bolt is to be attached to the holes in the roof corner bar.
14. Utilising the extra bolts inserted into each bar, attach the horizontal and diagonal bracing bars
in the same way as the original door end. Likewise with the door track support (to be found
with the door panels) attach as before.
15.
Now fit the small glazing bar over the doors to the unoccupied hole in the ridge gusset plate
and door track support.
16.
The doors in a partition are a little shorter/narrower than a standard door to facilitate full
opening. They are assembled and hung in the same way.
PARTITION DOOR TRACK
Fit the top door track to the partition gable in the same way as for the door end. To position the door
track into the correct position fit the partition door onto the track and by slightly releasing the 2 nuts
holding the door track support you can move the door up and down until it is correctly into the bot-
tom guide. The door should now run smoothly. If not you can ‘fine tune’ its operation by re-
adjusting the bolts up and down slightly.