Elite Greenhouses 8'5" Wide Thyme, Инструкции и иллюстрации

Страница: 15 / 40

DWARF WALL MODEL ONLY
Attach the door end cills to the corner bars. The door end cills are hand-
ed left and right. Each cill has a slot at one end and a tab at the other.
The slotted hole fixes to the corner bar.
Slide 4 bolts into the top (mitred end) of the 1st, 2nd and 4th and 5th
glazing bar. Attach the last bolt to the prefabricated hole in the roof cor-
ner bar. The 3rd shortest glazing bar is not fitted yet.
Moving to the bottom of each glazing bar, insert 1
bolt into the 1st and 5th glazing bar and attach to the
prefabricated hole in the cill.
Insert 2 bolts into the 2nd and 4th glazing bar. The
bottom bolt fixes the glazing bar to the cut out cill.
The cut out cill is positioned so that the ’u’ channel
to allow doors to slide, is on the outside.
Attach the 2nd bolt to the hole in the tab cill.
BOTH MODELS
Attach the main door track support (shaped like a
letter ‘Z’) to the 2nd and 4th glazing bars around 6”
down the bar as shown. This ‘Z’ shaped bar must be
fitted with the two outside slots facing upwards (as
illustrated)
not
downwards.
Now you can attach the smaller middle (3
rd
) glazing bar to the
ridge gusset plate and the unoccupied hole in the centre of the
main door track support. You may need to adjust the position
on the door track support to fit to the glazing bar.
Attach the small horizontal brace to the 2nd bolt inserted in all
vertical glazing bars.
The two long horizontal braces can now be attached to the
top
bolt
in the gusset plate and the remaining unoccupied bolts in
the vertical glazing bars. Shown below in the door end explod-
ed view.
Bolt the main door track to the main door track support by in-
serting 3 bolts into the bolt channel at the back of the door
track. Position these through the 3 holes in the door track sup-
port above the door opening. The door track should be posi-
tioned centrally. When this has been achieved tighten all nuts.
Please note, you only require approx. 200mm of beading in the
inside ‘v’ groove of the two end glazing bars. This is to allow
successful glass fitting above the door.
N.B. Please note carefully the correct position of the main door
track support. The slotted holes at either end are facing skywards
not
downwards.