Elite Greenhouses 8'5" Wide Thyme, Инструкции и иллюстрации

Страница: 21 / 40

ROOF VENT ASSEMBLY
The roof vent pack has 6 pieces of aluminium: and from the main box of fittings you require:
10’ of glazing beading 1 casement stay
6 M6 nuts and bolts 6 M4 stainless steel nuts and bolts
2 casement stay pins
PROCEDURE:
Identify the slam bar and attach the 2 stay pins to the outer side of the angle using the M4 stainless
steel nuts and bolts. The slam bar is a piece of 40 x 25mm angle cropped at each end to accommo-
date the glazing bars.
Lay the 5 edge pieces of the vent on a level surface as though you were on the inside of the vent
(with the bolt slots of the side bars uppermost and the ‘v’ slots of the bottom rail uppermost. The
top rail is arranged in such a way that the squared off (this face is notched with a ‘V’) end is to the
bottom and the hooked hinge uppermost).
Slide the glazing beading into the slot in the side and top rails and the intermediate glazing bar and
trim to suit.
Insert a bolt into each end of the side rail bolt slots, put these bolts through the holes in the top and
bottom rails, add nuts and lightly tighten. Check that all joints are secure and that the vent is square.
Fit the casement stay using the M4 stainless steel nuts and bolts, putting the bolts through the holes
in the saddle of the stay through the 2 elongated holes in the bottom rail. Hold the nuts in place and
tighten the bolts with a screwdriver. You must fit the casement stay before fitting the intermediate
glazing bar.
(Key point)
.
The intermediate glazing bar can now be attached to the central hole in the top and bottom vent rail.
Check that both side rails and intermediate glazing bar are fastened tight to the top and bottom rail
and pushed up/down as far as possible. Tighten all nuts.
Do the same with the other vents if applicable.