ELICA ALTAIR GRAY/F/50, Инструкция по монтажу и эксплуатации

Страница: 36 / 148

36
Operation
This product is designed to work with an Elica remote control,
either supplied with the product or purchased separately as an
optional.
To control the hood via remote control, the affiliation
procedure must be carried out.
CAUTION!
To begin, the hood must be disconnected and then
reconnected to the power supply and the affiliation procedure
must be carried out within the first minute of connection to the
power.
Read the instructions supplied with the remote control, which
provide detailed instructions on affiliation and correct use.
Note: Using the remote control, delayed shut-down can be
programmed based on the aspiration speed (power) enabled
at that moment:
Speed 1 (low aspiration): 20 minutes
Speed 2 (medium aspiration): 15 minutes
Speed 3 (high aspiration): 10 minutes
Control panel on hood
T1.
Suction speed (power) control key.
Press repeatedly until the desired speed is selected,
choosing between:
Speed OFF – LED L1 : off
Speed 1 (low suction) – LED L1 : green light
Speed 2 (medium suction) – LED L1 : yellow light
Speed 3 (high suction) – LED L1 : light blue light
Speed 4 (intensive suction) – LED L1 : light blue button
Note: Speed 4 has a limited duration of 5 min., and then
the hood passes automatically to speed 2 .
T2. Light control key (hob light-dim light)
Press briefly to light up the hob
Keep it pressed longer to light up the dim light
Note: The dim light is only available on some models.
Grease filter saturation warning - LED L1: red light
The warning is visible for about one minute after switching the
hood off.
When this warning appears, the grease filter
requires
maintenance.
Charcoal filter saturation warning - LED L1: red light
The warning is available for about one minute after switching
the hood off.
When this warning appears, the charcoal filter
requires
maintenance.
Deactivation/activation of charcoal filter saturation
warning:
This warning is normally activated, to deactivate it:
with the hood off, press the keys T1 and T2
simultaneously for more than 5 seconds.
LED L1 lights up red (signal on) and then begins to flash