elero MultiTec Touch-868, Руководство по эксплуатации

Страница: 16 / 27

30 | EN Ⓒ elero GmbH
Ⓒ
elero GmbH EN | 31
Valid for time-controlled travel commands: Select a target
run to the lower end position or the intermediate position or
ventilation position (differently sensible depending on appli-
cation roller shutter, Venetian blind or awning).
The currently activated selection is displayed brightly back-
lit.
3.9.2 Program position Up
Status line: Select program position up - channel number
Valid for time-controlled travel commands: Select a target
run to the upper end position or the intermediate position or
ventilation position (differently sensible depending on appli-
cation roller shutter, Venetian blind or awning).
The currently activated selection is displayed brightly back-
lit.
3.9.3 Priority clock
Status line: Change configuration - channel number
Priority automatic commands On or Off
Factory settings Priority off
The activated selection is displayed brightly backlit.
When the priority is activated, which means that automatic
time switching commands from the hand-held transmitter
channel are given priority in all receivers and accepted even
the manual operating mode of receivers.
3.9.4 Shading Clock
Status line: Change configuration - channel number
Shading Clock On or Off
Factory settings Shading off
The activated selection is displayed brightly backlit.
With the function Shading Clock activated: A time-controlled
down command switches off the automatic shading sys-
tem (privacy protection). A time-controlled open command
switches on the automatic shading system again.
3.10 Settings
→
Channels
→
Channel
→
Delete channel
Status line: Delete transmitter - channel number
3.10.1 Delete all
Delete all channels. All channels in the transmitter are
deleted. Terminate with safety prompt.
3.10.2 Delete channel
Deleting a single channel. Selected channel is deleted.
Terminate with safety prompt.
3.11 Settings
→
Channels
→
Channel
→
Activate programming mode
Status line: Programming the transmitter
3.11.1 Asynchronous programming
Multiple receivers connected to the same supply are all
simultaneously ready for programming for approximately 5
minutes after connection to the mains.