1 3
Chapter 9
I N S T A L L A T I O N M A N U A L |
9
MAINTENANCE INSTRUCTION
This part of the manual focuses on maintenance. To ensure the optimal
flame picture of your device, an annual maintenance by a competent
company or installer is prescribed.
9�1
MAINTENANCE IN THE COMBUSTION CHAMBER
During maintenance the glass windows of the fire need to be removed.
To do this follow the following steps:
9�1�1
(DIS)ASSEMBLY OF THE TRIMS
For a tight finish of the fireplace, trims are available. During maintenance
these trims must be removed, before the glass can be removed. The trims
are placed at the bottom and are kept in palce with magnets. Be carefull
when pulling them away to not scratch the glass.
9�1�2
REMOVE GLASS
To be able to cleam the glass on the inside, one needs to remove the
glass. To do this follow these steps:
•
Check, whether the trims are removed in as in step 10.1.1.
•
Remove the ropes holding the glass at the top side.
•
Put the section cup on the glass and make sure it is properly
vaccuumed, so it will not come off.
•
Carefully lift the glass out of the lower glass rail and tilt it out a bit.
Then lower it further next to the fireplace till it is clear of the top
bracket before putting it away. See
Figure 9.2
•
Carefully take out the corner glasses by pulling them outward a bit,
lifting them and tilting them out, see
Figure 9.3
.
•
Before taking out the inner glasses the glass brackets at the top
need to be unscrewed and removed, see
Figure 9.4
•
After removing the glass brackets place the suction cop on the glass
and make sure it is properly vacuumed.
•
The inner glass can be removed by lifting it up and tilitng it out
NB
: Put away the glass in a safe place, when you are not using it, to make
sure it will not damage during maintenance. Remove the suction cup
after putting away the glass to avoid tracing or stains.
9�2
CLEANING THE GLASS
Keep in mind the following when cleaning glass:
•
Always clean the glass at room temperature.
•
Use cleaning supplies qualified by Element4.
•
When you clean your Anti-Reflective glass, make sure you use
this with the special Element4 cleaner, which is available only via
Element4.
•
Use only a microfibre cloth. Other materials such as kitchen towels,
steel wool etcetera can cause scratches or damage the coating on
the glass.
•
Should there occur stains on the glass, remove them regulary, for
the can burn the glass.
Figure 9.1 |
Archtect series side view
