ELEKTRA MACINADOSATORE, Руководство пользователя

Страница: 32 / 40

gb
67
THE MACHINE DOES NOT HEAT UP (V)
If the machine was switched on by mistake without having filled the water circuit,
the heating element safety device might have been activated.
This device protects the electric heating element against damage due to momentary
overheating caused by lack of water.
Proceed as follows:
1) Proceed as indicated in chapter “E STARTING UP THE NEW MACHINE FOR THE FIRST TIME”.
2) Check that the machine heats up correctly: if it does not, switch off the machine
by putting the on/off button 1 to OFF and pull out the plug.
3) Wait a few minutes for the heating element safety device to reset automatically.
4) Connect the plug to the power socket and switch on the machine by putting the on/off
button 1 to ON. Check that the machine heats up correctly: if it still does not work
properly this means that the heating element has been damaged; have the machine
repaired by an ELEKTRA Service Centre.
CLOCK NOT WORKING (N)
If the clock does not work you must replace the battery:
1) Turn the clock glass 14 clockwise and take it out of its lodging by pulling it towards you.
2) Remove the clock from its lodging by pulling it towards you.
3) Replace the battery Mod. SR626SW.
4) Insert the clock in its lodging again and press it until it adheres to the body.
5) Insert the clock glass 14 in its lodging again and turn it anti-clockwise until it clicks,
which means it is properly locked:
The clock glass 14 will only fit in one position. Please take care that all four lugs are
aligned with the slots in the casing: do not force the glass into place.
INCREASED GRINDING TIME AND NOISE (M)
Said problem is caused by the wear of the mills, which in best conditions can grind
approximately 600 kilos of coffee before needing to be replaced.
Contact an ELEKTRA Service Centre.
3
4
5