Luno5 light switch manual
www.eledo.pl
4
- button
„ ” for manually turning lights on/off. In the bottom part of the switch, we can find an illuming
symbol that informs us
about the device mode. Illumination of this light along with dark display informs us about the manual mode of the switch. If the
symbol is illuminated and displays the exact amount of people then the device is in night blockage mode that prevents lights from
turning on until dawn when the device sensor is lightened.
- around the lights on/off switch
„ ”
we can find an illuming border that usually is illuminated in blue and after turning light(s) on,
changes color to white that informs the user that light is being turned on in the room.
We advise to first assemble the controller in a box and then direction sensors along with steering wires.
For Luno5 to work correctly it requires three electrical wires inside an electric box:
a) phase conductor (power cord)
b) receiving conductor (leading to the bulb)
c) neutral conductor
If box wiring is incomplete (e.g. no neutral conductor) then this can be fixed in different ways:
a) you can lead neutral conductor to box from another electrical wiring,
b) you can use the third conductor as neutral (if there is an installation for lighting separate bulbs in chandelier). In such a
situation one wire can be bridged with a neutral conductor or use a regular 25-100W bulb that w
on’t be used for lighting.
c) Luno5 can be powered by an additional 5V power supply that is available at
be used in 10 Luno5 devices). In such a situation a neutral conductor is no longer in use. The device can be powered by a
5V phone charger.
d) you can connect a 5V power supply from other Luno5 switches. Two Luno5 devices should be connected by a conductor of
at least 0.75 mm
2
cross section with use of one and two contacts (see additional devices socket).
To prepare the device for installation you should first remove the switch front panel by pulling it from the part, for assembly in the
box (see figure 4). While removing the front panel you should pull it steadily by holding fingers of one hand on opposite edges of
the front panel and by holding the rear side of the switch with the other hand. Y
ou shouldn’t pull the front panel only from one
side, this can damage the panel.
Fig. 4 Removing switch front panel before installation.
The rear part of the device has three G-clamps for connections of 230V electric wires (85V
– 240V) and after removal of the front
panel, the PCB contains two sockets. One is for the connection of direction sensors and the other is for optional connection of
the other additional elements
.
Connection of the Luno5
device to 230V lightning networks should be made by a person with proper electrical
eligibility! (lighting network contains dangerous voltages)!
The device has no fuses that could be blown after a short circuit. Make sure that fuses in the fuse box are properly
adjusted to the power of light bulbs inside rooms.