22
8
Cabinet requirements
This appliance has been designed to ‘slot-in’ to a 600mm wide gap built-in to standard
kitchen cabinets. As such the appliance can be installed matching the height and depth of
benches and behind the kick rail of the cabinets. This allows the cooker to integrate well
into contemporary kitchens. The cooker may also be installed at the end of a line of
benches with a free space on either side.
Warning: This appliance has been tested and approved to the relevant Australian
Standards. It is designed to cook food, it will get hot. Cabinet materials must
be capable of withstanding 85°C. Installation into lower temperature tolerant
cabinetry (eg vinyl coated) may result in deterioration of the low temperature
coating by discolour or bubbling.
Electrolux Home Products cannot accept responsibility for damage caused by installation
into low temperature tolerant cabinets.
Recommended cabinet design
Installation sequence
1 Check that the required services are
correctly positioned (see electrical and gas
services requirements section and cabinet
requirements section).
2 Ensure that cabinetry has correct details
(see cabinet requirements section).
3 Unpack the cooker.
4 Remove the foam pack containing
accessories.
5 Lift off the carton sleeve, lift cooker off
base, remove all packaging tape,
protective plastic coatings and foam
packaging. Leave all warning labels for
the customer.
6 Attach splash back using the three screws
provided, ensuring a square fit.
7 Remove the internal pack from the oven
and position shelf supports and grill trays
(see page 18).
8 On gas cookers position gas burners
and trivets (see pages 16).
I N S TA L L I N G T H E A P P L I A N C E
General power outlets must not
be positioned behind the
appliance or above the hob.
