ELECTRO FREEZE SLX400C, Руководство оператора

Страница: 35 / 74

ELECTRO FREEZE Soft Serve Models SLX400C
184582-01 25
Figure 9-2 Assemble beater shaft
assembly
Figure 9-1 Lubricate shaft seal
Figure 9-3 Lubricate bearing areas of
breaker bar
9 Assembly
Correct assembly of the freezer is
essential to prevent leakage of the
product and damage to the freezer. To
assemble the freezer you will need an
approved lubricant, such as Petrol Gel.
Make sure all parts of the assemblies
have been washed and sanitized before
assembling. Follow these directions for
each cylinder of the freezer.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure the control pad
is “OFF” and that the power
switch is “OFF”.
1. Persons assembling the freezer must
first wash and sanitize their hands
and forearms with an approved
sanitizer.
2. To assemble the shaft seal, install
the cup seals on the plastic washer
as shown in figure 9-1.
3. Apply a moderate amount of
approved sanitary lubricant (such
as Petrol Gel) to the beater shaft
as shown in figure 9-2. Install the
shaft seal over the rear of the beater
shaft, (figure 9-2). Do not allow any
lubricant to come in contact with the
bell-shaped rubber portions of the
shaft seal.
4. Apply lubricant to the bearing areas
of the breaker bar (figure 9-3).
5. Place the scraper blades on the
beater shaft, making sure the blades
are installed properly.
6. Slide the breaker bar into the center
of the beater shaft, making sure
the bar fits into the hole in the rear
beater shaft disc (figure 9-2).
7. Insert the assembled beater shaft
into the cylinder by placing the rear
blade on the bottom of the cylinder.
This will center the beater shaft
and allow alignment with the drive
coupling. Rotate the beater assembly
while pushing, until the shank has
engaged the coupling. Install both
beater shafts.
— continued