See
MG
(Mic Gain)
SET/RESP format:
MGxxx; where <xxx> is 000-080. For mic input selection, see
MI
. For
mic preamp configuration, use
MS
(Mic Setup).
MI
(Mic Input Select)
SET/RESP format:
MIn; where: <n> = 0 (front mic), 1 (rear mic), 2 (LINE in see
LI
cmd),
3 (front mic + LINE IN), or 4 (rear mic + LINE IN). For preamp, bias, and mic button
configuration, use MS (Mic Setup).
NOTE:
Mic selection only applies to voice modes. In audio data modes, LINE IN is always
used (audio jack or USB sound card input).
ML
(Transmit Monitor Level)
SET/RESP format:
MLmnnn; where m is 0 (CW), 1 (AF data), or 2 (voice), and nnn is
000-100. In CW/direct-data modes this is the sidetone/alert tone level; in voice modes,
speech monitor level; in AF data modes, data monitor level.
GET format:
MLm; where m is 0 (CW), 1 (AF data), or 2 (voice).
K3 SET/RESP format:
MLnnn; where nnn is 0-60 and applies to the current mode (see
above).
MS
(Mic Setup) [Pending]
SET/RESP format:
MSabcde; where:
<a> = front mic preamp
0 = 0 dB, 1 = 10 dB, 2 = 20 dB
<b> = front mic bias
0 = OFF, 1 = ON
<c> = front mic controls
0 = UP/DN buttons disabled, 1 = UP/DN enabled
<d> = rear mic preamp
0 = 0 dB, 1 = 14 dB
<e> = rear mic bias
0 = OFF, 1 = ON
SET ONLY extensions:
MSAx; MSBx; MSCx; MSDx; MSEx; where: x is desired value.
NA$
(Auto Notch)
SET/RESP format:
NA$n; where n=0 is OFF, n=1 is ON. Only applies to SSB modes.
TOGGLE format:
NA$/; turns auto-notch on if it was off and vice-versa.
