LI
(Line Input) [Pending]
SET/RESP format:
LIuuullls; where:
<uuu> = line in level, USB-B
0-??? (actual range TBD)
<lll> = line in level, line in jack
0-???
<s> = line in source
0 = Sound card (USB-B), 1 = LINE IN jack
SET ONLY extensions:
LInnns; (set level and source)
LInnn; (set level for current source)
LIs; (set source)
NOTE:
In voice modes, audio from the specified line in source is only enabled if the
mic-input command (
MI
) is configured for LINE IN, FRONT+LINE, or REAR+LINE.
Disabled in CW, PSK-D, and FSK-D modes.
LK$
(VFO Lock) [Pending]
SET/RESP format:
LK$n; where n = 0 (unlock) or 1 (lock).
LN
(VFO Link) [Pending]
SET/RESP format:
LNn; where n = 0 (VFOs not linked) or 1 (VFOs linked; turns on link
icon to the left of the VFO B numeric display). When the VFOs are linked, VFO A controls
both VFOs. If VFO B is offset from VFO A, the offset amount will be preserved as VFO A
is tuned.
LO
(Line Out) [Pending]
SET/RESP format:
LOlllrrrm; where:
<lll> = left line level
0-040 (actual range TBD)
<rrr> = right line level
0-040
<m> = mode
0 = Right channel is independent
1 = Right channel uses Left channel value
NOTES:
(1) Line out audio is always available at both the LINE OUT jack (analog AF
out) and the sound card interface. (2) The CODEC on the AFIO allows Windows PCs
to independently adjust L/R audio *in* (PC perspective). This is a K4-only feature (the
CODEC on the KIO3 didn't allow independent adjustment). If the operator is using
Windows to control this, they can specify R=L feature in the LINE IN UI (<m> = 1
above).
