3.7 Changing the set temperature when working with electrical heater.
From the main screen, press
„up“
to enter the fast mode to
change the temperature set in menu
„EL Set
Temperature“
. Next pressing of the arrows
„up“
or
„down“
changes the value. If one of the buttons
„up“
or
„down“
remains pressed more than 0.8 sec., the value of the set
temperature starts automatically to increase or decrease
accordingly at a rate of 4 units per second. The new set
temperature will be saved by pressing Enter or by not
pressing any buttons for 5 seconds:
The temperature set is used only when heated with an
electric heater!
The temperature limits are set between 20 and 75°С.
It is better to use the
„EL Heating Settings“
menu because through it can be controlled not only
the temperature for switching off the heater, but also for switching on.
3.8 Setting the timer for additional heating with electric heater (menus „EL Boost Timer 1“
and „EL Boost Timer 2“)
Setting the hour intervals allowed for additional heating of
water by electric heater. When a timer is active and time is
currently in its range, the electric heater will switch on to
heat the water, and shall use the temperature in the column
"Temp"
as set temperature and it will switch on if the
temperature of the lower thermo-sensor t1 drops by 5
degrees less than the temperature set in
"Temp"
. The timer
allows exclusion of certain days of the week during which he
will not act. It happens by darkening the glowing green
LEDs.
Note that the time in the column
"Begin"
can not be later
than the time in column
"End"
! The setting of such values is impossible and therefore you may first
need to change the time in the column
"End"
and thereafter in the column "
Begin"
!
You can set very low temperatures in the electric heater menu
"EL Heating Settings"
and only
when you expect that you need hot water by turning on the timer you can force the electric heater to
switch on. If by then the solar system or boiler is warmed enough the water, the electric heater will
not turn on and you will save electricity costs. Meanwhile, if the sunlight was not enough, the heater
will turn on and you will not run out of hot water!
3.9 Setting electric heating (EL Heating Settings)
The temperature to which the water in the tank is heated
with electric heater is
"El Setting temp."
, and the
temperature below which it is compulsory to switch on the
electric heater is
"Heater On temp."
and which sensor to
take into account the temperature for switch on the heater
"Bottom sensor t1"
or
"Middle sensor t5"
. Keep in mind
that the temperature set to which the water in the tank is
12
