© Elcom s.r.o.
Euro-2000M Alpha
Program manual
31
3.5. Logo programming.
Up to 6 lines of logo may be printed at the beginning of the receipt ( e.g. Roys Food Store, Thank you etc.).
Each line can contain up to 24 characters of normal size, or up to 12 characters of double size.
Text programming is described in the hexadecimal or alphabetic character table on preceding pages. To
enter the letters of A to F use the department buttons of
;
to
@
respectively. Enter the numeric values 0 -
9 by means of the numeric keyboard.
3.5.1. Logo programming procedure
Turn the mode key to the program position P and press the
P
(PO) button. The number of the pro-
grammed logo line in the first display line and the programmed text in the second line will appear in the
display. Enter the hexadecimal codes for the whole logo line and press the
V
button. The next line will
appear in the display.
If you make a mistake during the programming, correct the previous characters by pressing
H
(CLEAR)
key.
To print the logo and check for correctness of programming, press the
Q
(CHECK) button. Printing of a
particular logo line is possible by pressing
G
(RECEIPT).
Finish the logo programming by pressing the
W
button.
The programming logo procedure:
1.logo line
Elcom s.r.o.
Display:
The programmed text Elcom s.r.o. in the first line of logo.
Character codes
Line number
Next lines
Skip line
From line No.1
V W
0 @
...
1 6
...
P
Note: Before text programming, it is recommended that hexadecimal strings, representing texts, be pre-
pared on a sheet of paper. The character table sorted in alphabetic order will make finding corre-
sponding hexadecimal codes much faster. The cash register printer will print programmed charac-
ters gradually from left to right.
3.5.2. Correction of the logo lines
Turn the mode key to the P position. Enter the line number that you want to correct and press the
P
(PO)
button. Continue in the same way as in logo programming.
3.5.3. Printing the programmed logo lines
Preprogrammed logo lines can be printed in programming mode by pressing the
Q
button. Print particular
preprogrammed line by pressing the
G
button.
