ELM-4D1P
instruction manual
IM443-U v0.7
pag. 5
DESCRIPTION FRONT PANEL– OPERATORS
VA
V
L-L
LEGEND:
A
: push-button for the visualization of electrical parameters of three-phase system with the corresponding LED
indication. In modality programming (SETUP) it’s used to confirm the parameter set.
B
: push-button for the selection of the electrical parameter to be displayed on display
F
. In modality programming
(SETUP) it’s used to increase the value of the parameters to set.
C
:
push-button for the selection of the electrical parameter to be displayed on display
G
. In modality
programming (SETUP) it’s used to reduce the value of the parameters to set.
D
: LED bar for the indication of the electrical parameter displayed on display
F
.
E
: LED bar for the indication of the electrical parameter displayed on display
G
.
F
: 3 displays for the visualization of electrical measures of every phase.
When
Σ
L
LED is ON, only the main display will be active showing the three-phase system value of the
electrical measure selected.
LED
k
and
M
show the eventual multiplying factor (k = kilo=x 1.000, M =Mega= x 1.000.000)
Using the
C
key the display indicates also the values of the active and reactive energy counters.
Using the
A
and
B
keys the display indicates the maximum and average values.
G
: display for the visualization of the electrical measure indicated in LED
E
(energy counters excluded).
The voltage values are referred to the three-phase system.
The
k
LED displays the reading in kilo (x 1000).
Using the
C
key the display indicates the type of the energy displayed.
Using the
A
and
B
keys the displays indicate the type of the value: average or maximum.
A+C
:when pressing simultaneously the instrument pass to the following menu:
- instrument programming (SETUP)
- energy counters and peak values deleting (RESET)
- digital outputs programming (SET DO1
;
SET DO 2)
- analog output programming (SET AN OUT)
- hour counter programming (HR_)
- I/O diagnostic page
A+B
:when pressing simultaneously the instrument pass to the visualization of average and maximum values
stored.
MENU OF INSTRUMENT PROGRAMMING
(
SETUP
)
To enter in SETUP it’s necessary to press at the same time
A
and
C
keys, on the
F
display will appear the message
SeTUp. Pressing the
A
key on the
G
display will appear the message SET that will remain always displayed during
the set of each parameter to highlight the setup phase in running.
The set values will be keep also in absence of auxiliary power supply.
