16
ELBE Wireless Radio-Keypad
Programming
Installation
Before physically installing the unit in its mounting position it is good practice to perform a practical test to assess the functionality and
effective range. Please bear in mind that range may be up to 25 or 30% less when battery power is low.
Positioning
Apart from the distance from the receiver, the units should not be positioned in the vicinity of or -
worse still - in contact with metal structures, which could otherwise exert a signal shielding effect. Thanks
to the enclosure protection rating of IP 54, the digital selectors can be installed outdoors if required.
A
: Changing the combination associated with channel 1 ◄ - Example:
This function allows you to change the combination associated with channel 1 ◄
1. Press the "0" key and hold it down while pressing and releasing 0 ◄
2. Release the "0"key
3. Type in the current number (original factory is,11) combination and press 11◄
4. Type in the new combination (up to 8 digits) and press ◄ ( e x a m p l e ) 12345 ◄
5. Type in the new combination again 12345 ◄
6. To enter the code
for the START control,. With the gate closed locate the P3 LEARN button and push the button once.
7. While DL6 is flashing, dial in the new combination generated at step 4&5, (12345) followed by the ◄symbol.
B
: changing the combination associated with channel 2 ► - Example:
This function allows you to change the combination associated with channel 2 ►
1. Press the "0" key and hold it down while pressing and releasing 0 ►
2. Release the "0" key ►
3. Type in the current (original) combination and press 22 ►
4. Type in the new combination (up to 8 digits ) and press ► ( e x a m p l e ) 23456 ►
5. Type in the new combination again 23456 ►
6. To enter the code
for the PEDESTRIAN. With the gate closed press P3 button (PROGR) button twice; LED DL6 will start to flash
quickly.
7. While DL6 is flashing, dial in the new combination generated at step 4&5, (23456) followed by the ►symbol.
Factory reset of the keypad if the current code is lost/not known.
Dis-assemble the keypad and locate the hidden button inside the unit. Press and hold the button down for 10
seconds, the unit will emit a long beep. Re-assemble the keypad and proceed to reprogram as per the
beginning of this instruction.
