10
Programming the 207C circuit board
Before you start to programme!
Check that the gate wing stops are in place and set!
Check that you have wired the photocells correctly and bridged (linked) the normally closed (N.C) circuits that are not being
used. If you have done this correctly, you should have these LEDs illuminated with the power to the circuit board on.
The first two LEDs from the left should only appear when an open command or a pedestrian command is given. If the fourth
from the left LED is missing check your photocell wiring circuit and alignment of the beams. If any other LEDs marked ON
are not illuminated, check the circuits or the links outlined on the typical wiring diagram page.
STEP1 Programming the remotes
*Note* Carry out programming the remotes only with the aerial disconnected from the PCB. This avoids picking up stray frequency codes from
other equipment. Reconnect only when you have finished programming the remote control equipment.
STEP4 Verify motor direction
You need to verify that the motors are going in the right direction in relation to the panel. Arrange gate’s so that the y are both
approximately half way. Turn the power off to the panel.
(It is important that you leave the power off to the panel at least 15 seconds
or the fuse may fail when you turn back on the power)
Turn the power back on again. Press once the key fob that you previously
learned in at step 2 and 3. Observe the direction that both gates move in at the start and then immediately turn the power off again. The
gate if that travels in an open direction is correct. The gate that travels in a closing direction is incorrect. Identify this motor at the PCB as
M1 or M2 and these motor wires need swapping with each other.
STEP1
with KW113 remote,
open the cover and randomly arrange the
dip-switches first.
STEP1
with A3a-V2 and I8
remotes,
Carry out the
How to generate a
random code procedure.
WITH JANE REMOTES GO
STRAIGHT TO STEP
2
STEP3
.
While the DL6 is flashing,
press and hold the button
on your remote you want
to open the gate fully for 3
seconds.
STEP2
Enter radio code programming (for the
START control).
Press and release
the
LEARN.
button once, the LED
DL6 will start to flash. .
Go to STEP3.
The board accepts the code and exits
from programming (DL6 turns off). It is
possible to store up to a maximum of
32 different codes for the START
control.
O
N
O
N
O
N
O
N
How to generate a random fob code for A3a-V2 and I8 Remotes
Press and hold button (1)
Keep button (1) pressed then press and hold button (2) (The led flashes slower)
Keep both buttons pressed for 15 seconds (The led will start to flash faster).
Whilst still holding in buttons (1) & (2), Release button (1) wait 2 seconds and
release button (2).
You have now generated a random code in both buttons.
This code can now be learned to the radio receiver card.