14
Programming automation closing
Before you change the gate/s to automatic closing, consider that the gates will be operating unattended and could close while a
vehicle is within the swing area of the gates. Adding another set of photocells to the system as pictured on page 6 and wire in as
page 5 wiring to prevent this situation.
(Make sure the gates are closed first)
1)
Enter manual programming. Press and release the P3 button
(LEARN)
The LED DL6 will start to flash.
2) Start timing pause length
.
Press and release the P1
(BREAK)
button. The timing of pause length starts (automatic re-closing time);
led DL6 and the warning lamp start to flash at high frequency.
End timing pause length
.
Press and release the P1
(BREAK)
button; timing of pause length ends (automatic reclosing time). The board
automatically exits from manual programming
(LED DL6 and the warning lamp turn off) and sets the time for automatic closing
between the two pressures of P1
(BREAK)
key.
DELETING AUTOMATIC CLOSING
1)
Enter manual programming.
Press and release the P3 button
(LEARN
) button. The LED DL6 will start to flash.
2)
Deleting automatic closing time Press and release the P1
(BREAK)
button
twice.
This sets the automatic closing waiting time to zero.
LED DL6 turns off.
PROGRAMMING RADIO CODE (START CONTROL)
1)
Enter radio code programming (for the START control).
Press and release the P3 button
(LEARN
) button. The LED DL6 will start to
flash.
Use the transmitter to send the radio code to be stored and associated with the START control. The board accepts the code and exits from
programming (DL6 turns off). It is possible to store up to a maximum of 32 different codes for the START control.
PROGRAMMING RADIO CODEP (PEDESTRIAN CONTROL)
1)
Enter radio code programming (for the PEDESTRIAN control).
P3 button
(LEARN
) button twice; LED DL6 will start to flash quickly.
Use the transmitter to send the radio code to be stored and associated with the PEDESTRIAN control. The board accepts the code and
exits programming (DL6 turns off). It is possible to store up to a maximum of 32 different codes for the PEDESTRIAN control.
DELETING RADIO CODES:
Press the
P3 button
(LEARN
) button and the P1
(BREAK)
button
simultaneously
(LED DL6 will flash at a
high frequency); keep them pressed for at least 10 seconds (until LED DL6 goes off), all the stored radio codes (associated with both
START and PEDESTRIAN) will be deleted.
