Elation DESIGN SPOT 575E, Инструкция пользователя

Страница: 31 / 48

Design Wash 575E™
©Elation Professional® 31 Design Wash 575E™
approximate size of the room (NORM, BIG, MIDL, SMAL). The built-in programs
will automatically adjust to your selection to optimize light output for your room.
9.2.1 Use the sound sensitivity knob on the side control panel to make the unit more
or less sensitive to sound. Turning the knob in clockwise direction will make the
unit more sensitive to sound, while turning the knob counter-clockwise will make
the unit less sensitive to sound. Note: This unit will react to the low frequencies
of a sound source, tapping on the fixture or high pitched sound may not trigger
the fixture.
9.2 Master-Slave Operation (Sound Active): This function will allow you to link up to
16 fixtures together and operate without a controller. The fixtures will be sound
activated. In Master-Slave operation one fixture will act as the controlling fixture and
the others will react to the controlling fixtures programs. Any fixture can act as a
Master or as a Slave.
9.2.1 Using standard XLR microphone cables, daisy chain your fixtures together via
the XLR connector on the rear of the fixtures. Remember the Male XLR
connector is the input and the Female XLR connector is the output. The first
fixture in the chain (master) will use the female XLR connector only - The last
fixture in the chain will use the male XLR connector only. For longer cable runs
we suggest a terminator at the last fixture.
9.2.2 Follow the same procedures listed in the previous Stand-Alone section. With
two exceptions; Be sure the first unit in the chain is selected as the
“master“(MSTR) is turned on in the audio submenu. All other fixtures must be
in “slave“ mode (SVPT) turned on in the audio submenu.