/ 33 /
FREQUENTLY ASKED QUESTIONS
Q
Is this kit, namely the water block, compatible with narrow serv-
er type LGA-2011 motherboard? How about older LGA-1366
and -755?
A: Narrow server type LGA-2011 is not supported by de-
fault – a Mounting plate Supremacy LGA-2011 Narrow
ILM [EAN: 3830046990600] is mandatory to install
this water block on narrow server type LGA-2011 mother-
boards. Replacing the mounting plate requires disassem-
bly of the water block.
LGA-1366 and LGA-775 owners should follow the installation manual for
installation on AMD® socket motherboards. However it is required to re-
move the inner core of the CPU backplate rubber gasket. This is true for
both scenarios.
Q
How many water blocks can you add to the loop?
A: The EK-KIT EXTREME liquid cooling unit can be upgraded with several
additional parts. However in order to keep performance at a reasonablelevel
it is recommended not to upgrade EK-KIT EXTREME with no more than:
- one (1) GPU water blocks (EK-KIT X240)
- two (2) GPU water blocks (EK-KIT X360)
The pump itself can manage the restriction of having up to 4 GPU water
blocks however the loop has to be extended with an additional radiator units.
Q
What flow rates are to be expected with EK-KIT EXTREME?
A: This kit typically operates at about 400L/h.
Installing a typical GPU water block typically drop flow rates from 400L/h to
about 350L/h. Adding two water blocks would result in flow rates of about
320L/h in the same scenario.
For best performance it is recommended to run the pump at 100% duty cycle
in order to maintain highest flow rates (and thus thermal performance) when
running more than one additional water block.
Q
Can the Push-Pull Fan configuration be used with EK-KIT X?
A: Yes, this kit can take accomodate additional fans on the bottom side and
thus work in push-pull regime. However, the required mounting screws
are not enclosed and must be purchased separately.In order to prevent
damage to the unit please use the UNC 6-32 30mm screws with stand-
ard 120x120x25mm fans!
The required set of UNC 6-32 x 30mm screws can be
purchased through EK Webshop and EK Partner Reseller
Network.
Q
Is it possible to ‘daisy-chain’ the enclosed PWM splitter?
A: Yes, the enclosed PWM splitter allows for daisy-chaining of additional
PWM splitter cables, such as EK-Cable Y-Splitter 2-Fan PWM (10cm)
[EAN: 3831109867860], as long as the total power draw does not ex-
ceed 12W (1A on +12VDC) - the limit of KK 254 4-pin fan header on the
motherboard.
