/ 23 /
STEP 4
Push the reservoir against the clamps. It should
smoothly slide and lock into them.
These holders allow rotating the reservoir or sliding
it up and down a bit – depends on the distance be-
tween the clamps.
STEP 5
Fix the position of the reservoir by tightening the ad-
justment screw on each clamp.
Use enclosed 2,5mm Allen key.
STEP 6
The reservoir has multiple G1/4 ports,
which can be used as inlet or outlet port.
Please choose the inlet or outlet port de-
pending on your loop configuration and
space constraints.
Tighten the fitting barbs in clockwise direction until
the gasket underneath is compressed.
The installation of the reservoir is now complete.
STEP 4
Reservoir
STEP 5
2,5mm Allen key
Mounting clamps
Mounting clamps
PC Chassis
STEP 6
Fitting
Ring
Fitting
Barb
Reservoir