/ 21 /
STEP 2
The position of the unit in the chassis depends on the fan mount-
ing holes and the hardware you have installed. Usually the chassis
have Pre-drilled standard fan mounting holes on the sides one
you should look for holes with spacing of 105mm. (A standard
computer cooling 120mm fan).
Alternatively you can drill four Ø4,5mm holes using
electric power drill to the most suitable place on the wall
of your computer chassis.
Put four M4x6 DIN7984 screws through the holes on the UNI
pump bracket from the front side.
STEP 3
Secure the M4x6 screws from the previous step with four M4
nuts and PVC washers. Tighten them using 2,5mm Allen key with
the screws.
Make sure that the screws are holding tight but do not
exaggerate with the force applied.
STEP 4
The pump unit has clearly marked Outlet (OUT) around
the G1/4 port. Not taking that into account will lead to
reverse fl ow.
Tighten the fi tting barbs in clockwise direction until the gasket un-
derneath is compressed.
The installation of the pump unit is now complete.
STEP 2
Pump unit
120mm fan UNI
pump bracket
PVC washer
PC Chassis
STEP 3
STEP 4
PC Chassis
PVC washer
M4 nut
Fitting
Ring
Fitting
Barb
