/ 19 /
INSTALLING THE PUMP UNIT
OPTION 1:
INSTALLING THE PUMP ON THE
CHASSIS BOTTOM
STEP 1
The KIT comes with pump unit with pre-installed anti-vibration decouplers.
Take the unit and place it on the EK-UNI Pump Bracket (120mm Fan) Verti-
cal, as shown on the picture.
Turn your pump in any direction, as long it is not turned upside-
down.
Secure it from the bottom side using four M4x4 screws and PVC washers.
Tighten them in clockwise direction using enclosed 2,5mm Allen key.
This unit can be installed anywhere where there is a 50x50mm
square mounting hole pattern on the chassis without using any
pump bracket.
STEP 2
The position of the unit in the chassis depends on the fan mounting holes
and the hardware you have installed. Usually the chassis have Pre-drilled
standard fan mounting holes on the bottom one you should look for holes
with spacing of 105mm. (A standard computer cooling 120mm fan).
Alternatively you can drill four Ø4,5mm holes using electric pow-
er drill to the most suitable place on the bottom of your computer
chassis.
Put four M4x6 DIN7984 screws through the holes on the UNI pump
bracket from the upper side.
STEP 1
STEP 2
Pump unit
120mm fan UNI
pump bracket
PVC washer
M4x4 screw
PC Chassis
Pump unit
120mm fan UNI
pump bracket
M4x6 screw