Pellet burner GP xx sc 19
If the gathered fuel over the burner’s fire-grate has not been removed, after
successful ignition (for example after restarting the burner) it might lead to difficult
firing of relatively larger amount of fuel, to separation of inflamed gasses and
respectively to their explosive ignition. Such explosive ignitions might lead to
mechanical damages of the appliance, to which the burner’s main module is
mounted.
If the photic sensor does not register a burning process during operation, then the
fuel ignition algorithm starts again;
If two unsuccessful attempts for ignition have been performed, for example in case
the fuel has been depleted, then the burner stops the main algorithm and transits to
emergency mode, which is shown on the display panel and should be considered as
a necessity for intervention by the user, as the failure reason requires removal. After
the failure has been removed the new start has to be performed through consecutive
switching OFF and then back ON (restarting) of the appliance’s common power
supply, to which the burner is also connected.
Before starting the burner’s fire-grate has to be checked for presence of
unburned fuel and ash. If so, the fuel and the ash residues have to be removed.
If the power supply has been interrupted the burner will start automatically when the
supply restores.
During operation the burner might transit to final combustion and blowing, if the
relevant option for cleaning during operation is switched ON – parameter
“Max.comb.time”.
This parameter is in
“Advance menu”
,
as the access to it is
password protected.
6.2.5. OPERATIONAL PARAMETERS FOR ADJUSTMENT OF A PELLET BURNER „GP
XX SC”.
The operational parameters are preliminary set in the burner’s control module by the
manufacturer, as the user and/or other attending staff are not required to perform changes.
In order to achieve optimal and economic operational conditions of the burner it is necessary
to assign such heating output that will provide optimal operation and low fuel consumption.
The practice shows that the constant operation of the burner provides optimal fuel
consumption.
The controller’s display panel and the keyboard are used to show information about the
burner’s operation mode. The operational parameters adjustments have to be performed by
trained specialist.
