EKOM DK50 Plus Mobile, Инструкция по установке, эксплуатации и обслуживанию

Страница: 34 / 104

DK50
DK50 PLUS
NP-DK50_5 - 32 - 10/2009
Fig.14
Fig.15
For compressor models DK50 S, DK50-10 S and DK5010-S/M the case must be removed
before beginning the following procedures.
For DK5010-S/M - first disconnect the regeneration valve (Fig.5).
For DK50 PLUS S, DK50 PLUS S/M - unlock the lock on the door and open the housing door (Fig.6)
15.2. Safety valve check
(Fig.10)
When the compressor is operated for the first time, make sure that the safety valve is working properly. Turn
screw (4) of safety valve (1) several rotations to the left until the safety valve releases air. Let the safety
valve blow out for only a few seconds. Turn screw (4) to the right until it seats, closing the valve.
The safety valve must never be used for depressurizing the air tank. It could damage the
safety valve. The valve is set to the maximum permitted pressure by the manufacturer.
Adjustments are not permitted.
Warning! Compressed air can be dangerous. Wear eye protection when blowing air out.
15.3. Replacement of input filter
(Fig.13)
It is necessary to replace the input filter (1) located in the lid of crank box of a
compressor.
•
Pull out the rubber plug (2) using a hand.
•
Take out the used and contaminated filter.
•
Insert new filter and put on a rubber plug.
15.4. Replacement of output filter in air dryer
Before beginning, reduce the air pressure in the tank to zero
and disconnect the appliance from the mains.
(Fig.14)
In the case of a regular operation of a dryer it is necessary to replace the dryer
filter in the upper part.
•
Remove the dryer plug (1) by unscrewing to the left from the dryer head (4).
•
Put in a new filter (2).
•
Refit the dryer plug to the dryer head (4) and tighten it to the right.
15.5. Replacement of filter in condensation and filtration unit
Before beginning, depressurize the air tank to zero and
disconnect the appliance from the mains.
(Fig.15)
In the case of a regular operation of a condensation unit it is necessary to
replace the filter inside the filter with automatic desludging.
•
Release a safety lock (1) on the filter vessel by its pulling downwards, slightly
rotate the filter cover (2) to the left and take it out.
•
Unscrew the filter holder (3) by its rotation to the left.
•
Replace the filter and fix the new one by rotation of the holder to the right
back on the filter body.
•
Replace the filter cover and secure it by turning to the right until the safety
pin locks.
Fig.13
1
2