EKOM DK 50 4X2VT/M, Руководство пользователя

Страница: 45 / 60

PRODUCT MAINTENANCE
06/2022 45 NP-DK50-Nx2VTM-ADM-EN-1_06-2022
PRODUCT MAINTENANCE
22. PRODUCT MAINTENANCE
The operator should carry out
device checks regularly in the
intervals defined by applicable
regulations. Test results must
be recorded.
The equipment has been designed and
manufactured to keep maintenance to a
minimum. The following work must be
performed to preserve the proper and reliable
operation of the compressor.
Unauthorised interference
hazard.
Repair work outside the
framework of standard
maintenance (see Chapter 22.1)
may only be performed by a
qualified
technician (an
organisation authorized by the
manufacturer)
or the
manufacturer’s customer
service.
Standard maintenance work
(see Chapter 22.1) may only be
performed by the operator’s
trained personnel.
Only use manufacturer-
approved replacement parts
and accessories.
Danger of injury or equipment
damage.
Prior to commencing
compressor maintenance, it is
necessary to:
- check if it is possible to
disconnect
the
compressor from the
appliance in order to
avoid any risk of injury to
the person using the
appliance
or other
material damage;
- turn off the compressor;
- disconnect it from the
mains (pulling the cord
out of the mains socket);
- vent the compressed air
from the air tank.
Prior to commencing dryer
maintenance work, first:
- shut off the compressed
air supply to the dryer
- turn the main switch on
the
side of the
switchboard to the “0”
position;
- check the pressure
indicator on the dryer
and if there is still
pressure, it must first be
vented from the dryer
chamber.
Venting compressed air poses
an injury hazard.
Wear eye protection, i.e.
goggles, when venting
compressed air from the
compressed air circuit (air tank)
and from the dryer chamber.