EKOM 447000001-066, Руководство пользователя

Страница: 48 / 72

PRODUCT MAINTENANCE
NP-DK50-9x4VRTM-AD-EN-5_04-2022 48 04/2022
PRODUCT MAINTENANCE
18. RODUCT MAINTENANCE
The operator shall secure the
completion of repeated testing of
the equipment at least once every
24 months (EN 62353) or at the
intervals
defined by the
applicable national regulations. A
record of the test results must be
made (e.g.: as per EN 62353,
Annex
G), along with the
measurement methods.
The equipment has been designed and
manufactured to keep maintenance to a
minimum. The following work must be
performed to preserve the proper and reliable
operation of the compressor.
Unauthorised interference hazard.
Repair work outside the
framework of standard
maintenance (see Chapter 18.1)
may only be performed by a
qualified
technician (an
organisation authorized by the
manufacturer)
or the
manufacturer’s customer service.
Standard maintenance work (see
Chapter
18.1) may only be
performed by the operator’s
trained personnel.
Only use manufacturer-approved
replacement
parts and
accessories.
Danger of injury or equipment
damage.
Prior to commencing compressor
maintenance, it is necessary to:
- check if it is possible to
disconnect the compressor
from the appliance in order
to avoid any risk of injury
to the person using the
appliance or other material
damage;
- turn off the compressor;
- disconnect it from the
mains (pulling the cord out
of the mains socket);
- vent the compressed air
from the air tank
.
Prior to commencing dryer
maintenance work, first:
- shut off the compressed
air supply to the dryer
- turn the main switch on the
side of the switchboard to
the “0” position;
- check the pressure
indicator on the dryer and
if there is still pressure, it
must first be vented from
the dryer chamber.
Venting compressed air poses an
injury hazard.
Wear eye protection, i.e. goggles,
when venting compressed air
from the compressed air circuit
(air tank) and from the dryer
chamber.