EKO INSTRUMENTS CO., LTD. VIP Checker HC-121 Instruction Manual V2
Pg. 28
5)
Entering serial numbers for VIP
There are three different methods to enter the serial numbers for VIP.
Using Barcode Reader
Read the serial number placed on the prepared VIP with Barcode Reader.
code mode
r. The mode is changed
to Barcode Reader mode.
Read the barcode by placing the Barcode Reader closer to the barcode on the VIP.
When the barcode is read successfully, a beep sound will come on and the barcode is displayed in
the box for serial number.
Assigning number automatically by Measurement Software
This is a method assigning the number automatically by Measurement Software. (The number
does not relate to the actual serial number)
Setup the mode to Counter Mode, inclement the counter in the order that Start button is pressed
for the channels to be measured; a random cha counter value are used as serial number of
the VIP. When the same channel is used, the number increases by +1 (inclement). The
operation is easier since the Barcode Reader is not used.
mode
from Menu Bar.
mode
appears.
Only five characters are can be registered on the
Setup display for the random character. It can be
setup individually for each channel, but the same
letters cannot be used in each channel.
Once the above setting is completed, the setup is
started.
Up to 5 random characters can be registered on header for each counter per sensor.
Example)
1ch VIP_Axxxx
2ch VIP_Bxxxx
3ch VIP_Cxxxx
4ch VIP_Dxxxx
5ch VIP_Exxxx
xxxx:Counter
The counter (xxxx) is made of 4 digit-numbers between 0 and 9999. When starting up the
software, the counter is setup at
inclement u
counter number will individually inclement for each channel. The
Operation menu.
Figure 6-38. Mode Setup
mode .
The Mode
selected will be
shown in gray.
Figure 6-39. Counter Header Setup
