eka KF 1001G, Инструкция по использованию

Страница: 11 / 19

_ Gas oven _ rev. 6 _________________________________________________MOD. KF 1001G – KF 1001G-HT
KF 1001G IX AL – KF 1001G IX AL-HT
_________________________________________________________________________________________ page 11 _
3.4 3.4 3.4 3.4 Injector replacement and adjustment of primary air (Fig. 6) Injector replacement and adjustment of primary air (Fig. 6) Injector replacement and adjustment of primary air (Fig. 6) Injector replacement and adjustment of primary air (Fig. 6)
WARNINGS
WARNINGS WARNINGS
WARNINGS!!!! Before you attempt this operation, make sure you shut off the gas ON/OFF tap
located upstream of the appliance and disconnect electrical power to the appliance.
Carry out the following operations in steps after removing the door on the right hand panel
of the oven:
- Loosen securing screw “V” with an 8 mm wrench and withdraw bush “B” toward the
right.
- Using a 13 mm wrench, unscrew and replace injector “U” with the appropriate injector
for the new type of gas installed, referring to table 3 and checking if the diameter is
stamped on it.
-
Adjust air bush “B” to the correct distance H, which is the distance in millimetres
between the flat seat of the injector-holder and the adjustment bush.
- Seal the screw and bush with paint.
-
Replace the door on its seat.
B
H
U
V
T
Key: Key: Key: Key:
B =
B = B = B = Primary air bush Primary air bush Primary air bush Primary air bush
T = T = T = T = Burner Venturi tube Burner Venturi tube Burner Venturi tube Burner Venturi tube
U = U = U = U = Injector Injector Injector Injector
V = V = V = V = Bush securing screw Bush securing screw Bush securing screw Bush securing screw
Gas Gas Gas Gas Pressure Pressure Pressure Pressure Injector diame Injector diame Injector diame Injector diameter ter ter ter Distan Distan Distan Distance ce ce ce H H H H
G30/G31
G30/G31 G30/G31
G30/G31 30/37 mbar
30/37 mbar 30/37 mbar
30/37 mbar 145 1/100 mm
145 1/100 mm 145 1/100 mm
145 1/100 mm 14 mm
14 mm 14 mm
14 mm
G20 G20 G20 G20 20 mbar 20 mbar 20 mbar 20 mbar 215 1/100 mm 215 1/100 mm 215 1/100 mm 215 1/100 mm 13 mm 13 mm 13 mm 13 mm
Table
Table Table
Table 3
3 3
3
Fig. 6 Fig. 6 Fig. 6 Fig. 6
WARNINGS WARNINGS WARNINGS WARNINGS!!!! After every adaptation to a new gas, make sure of the following:
- Using an indelible adhesive, apply the data referring to the new installation on the
technical data-plate.
-
Run the appropriate tightness tests on the gas circuit.
3.5 3.5 3.5 3.5 Instructions on replacing certain components Instructions on replacing certain components Instructions on replacing certain components Instructions on replacing certain components
WARNING WARNING WARNING WARNING!!!! Before you attempt this operation, make sure you shut off the gas ON/OFF tap
located upstream of the appliance and disconnect electrical power to the appliance.
A) Gas valve
-
Remove the door on the right panel of the oven.
- Unscrew the gas delivery and outflow unions to and from the valve.
-
Remove the electrical plug connected to the valve card.
- Remove the burner ignition and control cables.
-
Replace the valve, refitting the parts in reverse order.