7
Page 43
30/u:
Fit one of the striker plates to the middle of the
profile and the other approx. 65 cm from the top
edge. Make sure that the striker plates are fitted in
the way shown in the profile diagram.
Page 44
30/v + 30/w:
Attach the door profile with the hinge
blades to the right-hand side of the middle door
profile (refer to step 30/s). On the left-hand side,
attach the door profile to the striker plates (refer to
step 30/u).
Page 47
Assembly of the double door
31/a:
Attach the two right-hand door wings to the
door pivot profile with the
four
pre-assembled hinges.
Page 48
Note (Figure 31/c):
During assembly of the door wing stop (art. no.
84.080.41), make sure that the upper door wing
is opened further than the lower.
Page 49
31/d:
Attach the two left-hand door wings to the door
pivot profile with the
three
pre-assembled hinges.
Page 51
Figure 31/h:
External view of the lower part of the
door
31/h:
Before you fit the two door stays, open the two
door wings and mark on the door profile the positions
at which the clip stops against the door. Fit the door
stays at these points (Art. No. 57.013.32).
31/i:
Now align the striker plates which have already
been pre-assembled on the door hinge. The lower
striker plate on the long door wing is aligned so that
the latch can be pushed into the ear. The two upper
striker plates should be at the same level to allow a
padlock (not included with the greenhouse) to be
attached.
Page 52
31/j:
The DT latch mounted on the right-hand upper
door wing joins the two halves of the door. Rotate the
DT latch through 90 degrees until it clamps the
rabbet profile on the lower door wing.
31/k:
The left half of the door can be fastened with
the help of the two latches attached
to the long door wing.
Page 53
Pre-assembly of the window
Important note:
The step below describes the method for assembling
a single window. Repeat this step for the
second
window
.
Page 55
Important note:
The outside of the plastic web panels (with UV
coating) is marked „
Außenseite / Outside
“ at the
edge, and it is also the side onto which the
protective film has been stuck. Only remove
the protective film from the plastic web panel
you are currently installing.
Page 56
32/f:
Cut two 646 mm lengths from the window
sealing profile and slide them into the designated
guide rails on the side profiles of the window
(refer to the profile diagram).
Important note:
Once you have pulled in the window sealing profile,
slightly pinch the guide profile at the lower end so
that the rubber cannot slip out of the profile.
Page 57
Assembly of the window
Important note:
Repeat this step for the
second window
.
33/a:
Slide a window stopper from the front into the
corresponding guide rail in the ridge profile as shown
in the illustration and insert it as far as the second
roof strut.
33/b:
Then slide the window into the same guide rail
(refer to the profile diagram). Secure the window by
sliding in the second window stopper up to the
window.
Important note:
Make sure that the window is positioned exactly
between the roof struts so that a perfect fit is
ensured when closing the window.
Page 58
Assembly of the window stay
Important note:
The window stay is supplied unassembled
in a separate bag. This bag contains all the
parts you need to assemble the window stay.
Repeat this step for the
second window
.
31
32
33
34
ABA_SM_TeilGB.pmd
07.04.2006, 10:39
7
