15
5.4 Mounting and grounding the battery modules in the battery cabinet
1.
Slide the lower rack battery into the cabinet as shown, and connect the ground cable to the ring terminal
ground connector on the battery module as shown.
2.
Push the module inward until making contact with the rear face of the cabinet.
3.
Repeat steps 1 and 2 above with the 2
nd
lower rack module.
4.
Mount the lower rack retaining clip.
5.
Install the battery rack partition bracket as shown using the two M5 keps nuts provided.
Note: Remove the retaining clip from the bracket if mounted on the partition bracket before proceeding
with the following steps:
6.
Repeat steps 1 thru 3 above with the upper level battery rack.
7.
Mount the two upper rack retaining clips.
2
4
5
3
6
Upper rack
lower rack
1
7
Figure 12: Battery module installation.
