12
7.
Remove the PCS cabinet from its packaging and
stand upright. (not shown). Remove the front
cover.
8.
Assemble and mount the single lower-center
leveling bracket as shown in steps 3 and 4 above.
CAUTION!
The PCS cabinet is heavy.
Mechanical lift or two persons recommended.
9.
Lift the PCS cabinet onto the wall mounting bracket.
10.
Slide the PCS cabinet to the left such that it aligns
with the alignment tab on the mounting bracket.
11.
From the rear side of the cabinet, adjust the outer
wingnut on the single levelling bracket until the
cabinet is vertically plumb (level) to the wall. (see
image – step 6).
12.
Insert the PCS cabinet coupling gasket between the
two cabinets (lower-front). Slide the battery cabinet
towards the left until mating to the gasket.
13.
Place the coupling plate inside the PCS cabinet and
insert the four mounting bolts and washers through
to the battery cabinet side.
14.
Place star washers on the bolts on the battery side
of the cabinet.
15.
Mount the battery cabinet side coupling plate, and
fasten with the lock nuts. Torque to 10 – 15 in-lbs.
WARNING!
The mounting bolts of the flange
assembly are required to be fully secured, as
they provide the chassis grounding for the
battery cabinet. Torque nuts as specified in the
specification tables provided in this manual.
16.
Continuity test:
Check the continuity
between the cabinets using an Ohm meter. The
test reading must be zero Ohms at a bare metal
point inside each of the PCS and battery cabinets.
17.
Install the cabinet coupler end plate (see- LP kit) to
seal the hole on the battery cabinet.
18.
Optional: (This is not a load bearing anchor –
anchored conduit runs to the PCS are satisfactory). Install screws in leveling plates for PCS and battery cabinets
by inserting a screwdriver through the hole on the backside of the cabinets.
19.
Plug hole on back of cabinet using by inserting the hole plug from the front side.
10
Optional (hardware not included)
12
16
thru
18
19
X4
17
Figure 8: Installation instructions.
