24
Installation and Service Guide: Color Controller E-45
Installing Hardware
After power on, the network administrator should perform Network Setup, verify the network connection, verify that the
E-45 appears in the list of printers, and then print a few test documents from a networked computer that will use the E-45.
For more information, see
Configuration and Setup
, which is part of the user documentation set.
Starting the E-45 for the first time
This section describes how to start the E-45 for the first time after connecting the cables.
To start the E-45
1
Make sure that the power switch on the back of the E-45 is in the ON (|) position.
Figure 7:
E-45 power switch
2
Power on the E-45 using the power button (
) on the front panel.
Press once and release the button to power on the system. The power supply automatically senses the correct voltage.
Figure 8:
E-45 power button
Important:
The straight-through network cable at the customer site and the crossover Ethernet cable included with
the E-45 look similar, but are not interchangeable. Make sure that you connect the network cable to the upper RJ-45
port on the E-45 connector panel (see
1
Power switch
1
Power button
1
1