17
Installation and Service Guide: Color Controller E-45
Installing Hardware
•
The network administrator must install the user software shipped with the E-45 onto networked Windows and Mac OS
computers that print to the E-45 (user documentation is also included).
Note:
This document covers hardware installation and service and provides general information about connecting the E-45
to the customer’s network. Network Setup and configuration information exceeds the scope of this document. For Network
Setup and configuration information, refer the network administrator to
Configuration and Setup
, which is part of the user
documentation set.
Unpacking the E-45
The E-45 is assembled and shipped from the factory with all necessary cables (except the network cable) and
documentation.
Before you unpack the E-45, it is strongly recommended that you review all
on page 10 to avoid injury or
damage to the E-45.
•
The E-45 weighs approximately 20Kg. Be careful when moving the device.
To unpack the E-45
It is strongly recommended that you save all packing materials in case you need them later (for example, if you discover
something is damaged and need to return it). Do not immediately discard packing materials.
1
Open the box and remove the packing material.
Save the original boxes and packing material, in case you need to transport the E-45 at a later date.
2
Remove the contents from the top container. Inspect the contents for visible damage.
3
Set aside the remaining components from the top container.
4
Remove the top container and any packing material.
5
Carefully lift the E-45 out of the box.
If you notice shipping damage to any component, save the shipping container, in case the carrier needs to see it. Call the
carrier immediately to report the damage and file a claim.
6
Give the media pack to the customer or network administrator.
Let the customer or network administrator know that in order to take full advantage of the E-45, the user software must
be installed on computers that will print to the E-45.