73
Installation and Service Guide
Replacing Parts
To replace the battery
1
Access and open the E-35A (see
).
2
Locate the battery on the motherboard (see
3
Carefully push the clip away from the battery until the socket ejects the battery.
Figure 36:
Motherboard battery
4
Slide the battery out of its socket.
5
Wait two minutes to allow the motherboard electrical components to fully discharge.
6
To insert a new battery, slide it into the socket so that the positive (+) side of the battery faces up.
7
Press the battery down into the socket until it snaps into place.
Make sure that the battery is securely installed in the socket.
8
Reassemble the E-35A and verify functionality (see
9
Configure the date and time in Setup (see
).
To configure the system date and time
1
On a client computer that is connected to the same network as the E-35A, open a Web browser window.
2
In the URL field of the browser, type the IP address or DNS name of the E-35A, and press Enter.
The IP address is listed under the Network Setup section of the E-35A Configuration page.
Note:
If a message about an untrusted connection appears or you are asked whether you want to proceed, you can
safely ignore the message and proceed by clicking
Continue
to website.
3
On the WebTools home page, click the
Configure
tab.
4
Type the administrator account in User name and the corresponding password in Password, then click
Log In
.
You can enter “Administrator” or “admin” for the administrator account name. The default password is
Fiery.1
(case-sensitive). However, the site administrator may have configured a new password for the E-35A.
5
Select Fiery Server > Regional Settings and specify the current date and time, and click
Save
.
6
Click
Log Out
to exit Configure.
1
Clip
2
Battery
3
Socket (CR1) on motherboard
Important:
Failure to configure the time and date will cause the E-35A to hang when user software is being
installed on the E-35A.
1
2
3
