82
Installation and Service Guide
Replacing Parts
8
Reassemble the E-35A (see
).
9
Connect the external cables that you removed from the E-35A.
10
If you replaced the HDD with a new HDD, install system software (see
11
Verify the functionality of the E-35A (see
).
Restoring and verifying functionality after service
Complete your inspection and service by reassembling and verifying the E-35A.
To reassemble and verify the E-35A
1
Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables in the E-35A make sure that:
•
Covers are securely installed after routing cables.
•
Cables are not looped around internal circuit boards, or components (such as capacitors and resistors).
•
Cable routing does not interfere with the operation of internal components.
•
Cables do not lie on or against any internal heating element.
•
Cables do not interfere with removing or replacing components.
•
Cables do not interfere with opening or closing E-35A panels.
•
Cables are not tangled.
•
Cable slack is secured with tie wraps.
2
Restore the system to the upright position.
3
Replace any panels that you removed earlier, as described in
4
Reinstall the E-35A in the furniture, as described in
“To replace the E-35A in the furniture”
5
If you installed a new hard disk drive, install system software (see
).
Replacement hard disk drives are not shipped with pre-installed system software.
6
If you replaced the motherboard with a new motherboard, make sure that the new motherboard solves the
problem that you are troubleshooting (see
), and then transfer options to the new motherboard (see
).
7
Make sure to configure the date and time in Setup (see
8
Before you leave the customer site, verify the E-35A operation.
Warning:
Do not lift the E-35A without assistance. Follow standard ESD
handling internal components.