Efcon omy, Инструкция по установке и эксплуатации, Страница: 17 / 48

Installation & User Manual - Sampling Systems
Version 140618 UK
Page 17
3.5.5 Changing Program Settings
Select submenu Program Settings and press Enter .
Select from the following parameters. Press Enter to change its value.
Parameter Description
Start Date-time Enter date & time to start sampling (00-00 = off).
Stop Date-time Enter date & time to stop sampling (00-00 = off).
Stop after full containers Enter desired number of container to be filled, the
sampler then stop sampling & restarts when reset is
pushed.
Date time. Enter time & date. Change it when needed.
Password Enter a number from 1-9999 to change the password.
3.5.6 Changing Input / Output Settings
Select submenu Input / Output Settings and press Enter .
Select from the following parameters. Press Enter to change its value.
Parameter Description
Flow signal Select with
◄
or
►
to totalize the desired flow signal.
Pulse = totalize contact (>50 ms) on the pulse input.
Current = totalize a 4-20mA flow signal.
Pulse + Current = totalize contact on the pulse input,
current is only to display.
Pulse input value Select the pulse unit= 0=none, 1=m3, 2= l, 3=p
Also assign a value to the pulse contact, 0,1 -1000,0
(0,1 for current flow signal).
Current Value Enter the 20mA value of the current signal
2600,0m
3
/h max.
Input 1 config.
Input 2 config. Select with ◄ or ► to configure the inputs.
Choose from the following functions:
Start/Stop PRG, Start Program, Stop program
Take Sample, Next container, Start Cool unit,
Not in Use.
Output 1 config.
Output 2 config. Select with ◄ or ► to config. the outputs.
Choose from the following functions:
General Alarm, Sample Alarm, Temperature High,
Sampling Active, Sample OK, Error sample, 1 m
3
pulse,
0,1 m
3
pulse, containers full.
Communication settings ID# = Unit ID number, Asign a unique network ID
number, Pari= Parity (0=even, 1=odd, 2=none),
Baudrate (legal baudrates=300, 600, 1200,2400, 4800,
9600)
3.5.7 Changing Cool unit Settings
Select submenu Cool Unit Settings and press Enter .
Select from the following parameters. Press Enter to change its value.
Parameter Description
Cool Unit On/Off On and off set points cool unit.
Defrost cycle Fill in the desired interval (F) in hours and how many
minutes the Cool Unit needs to defrost (t).
Temperature. offset Temperature offset, to correct the temperature
measured inside the cabinet.
Defrost Time Fill in the desired time (in hours) to stop the cool unit.
Set to 0 hours to activate the Cool Unit again.
ECO cool Not available.