E F A P O W E R E V - H C - I N S T A L L A T I O N A N D U S E R M A N U A L
13 | 28
4.
Connect the cables
The
cables entrance shall respect
the
place
that was
assigned
to it at the bottom of the Unit:
EV-HC3 / EV-HC7
Left
grommet
–
Charging
Cable
(if applicable)
Middle
grommet
–
Communications
(refer chapter 5.3.4.4)
Right
grommet
–
Input
power
cables
(refer chapters 5.3.4.2 and
5.3.4.3).
EV-HC11 / EV-HC22
Left
grommet
–
Charging
Cable
(if applicable)
Middle
grommet
–
Input
power
cables
(refer chapters 5.3.4.2 and
5.3.4.3).
Right
grommet
–
Communications
(refer chapter 5.3.4.4)
5.
Connect the lid
Do not forget to re-connect the cables!
a.
Plug the earth cable on it (faston terminal)
b.
Plug the flat cable on the board (X14)
c.
Plug the card reader cable on the board (X6)
–
if applicable
6.
Screw the lid
First, tighten all 4 screws only to the point where they are snug.
Then, tighten the screws all the way starting with the lower screws.
